Isolated and Non Isolated D.C./D.C. Converters

Model 6080
The Amalgen Model 6080 DC/DC non-isolated converter is a high quality 3 Ampere capability switching mode regulator housed in a 22.5 wide standard DIN-rail case. Input voltage capability is from 56 Volts to within a few volts of the nominated output. Standard outputs offered are 5 volts, 12 volts and 24 Volts as these are the most needed outputs. Special outputs are available. A green LED is provided on the front to indicate output power available.
 

Model 6081, 6082, 6083 AND 6084
The Amalgen Model 6081, 6082, 6083 and 6084 are high quality isolated DC/DC converters packaged in a 22.5mm DIN-rail housing. Various versions are available including single (up to 5W), dual (1.5W per channel) and bipolar (up to a total of 5W for both channels). Most used input and output voltage combinations are available on short delivery however any combination listed can be supplied. The input is protected by an internal fuse and the output will sustain a momentary overload or short circuit. Input/output isolation is better than 500 Volts DC. A green LED is provided on the front to indicate output power available.


General specification
Size: 22.5W x 68H x 120D
Mounting: 35mm DIN-rail
Housing: Polycarbonate
Protection: IP40
Connections: Screw terminals
Weight: 175g
Non-Isolated Models
Load regulation: 1% no load to full load
Line regulation: 1% over full input range
Total noise: 50mV R.M.S. max.
Protection: Input fused
Current limit: 4A approx.
Ambient temp range: 0-55° Celsius
Isolated Models
Input voltage range: ± 10%
Input filter: PI network
Input protection: Internal fuse
Output voltage accuracy: ± 4%
Line regulation: 0.6% full input range
Load regulation: 1% no load to full load
Total noise: 25mV R.M.S. max.
Short circuit protection: Momentary

Model Input Volts D.C. Output Volts D.C. Output mA
6080-V0
6080-V1
6080-V4		 15-56
15-56
28-56		 5
12
24		 3000
3000
3000

Model Input Volts D.C. Output mA
6081-X0
6081-X1
6081-X2
6081-X4
6081-X6
6081-X11
6081-X12		 5
12
15
24
30
+/-12
+/-15		 300
115
90
50
40
50
40
6082-X00
6082-X11
6082-X22
6082-X44
6082-X66		 5V/5
12V/12
15V/15
24V/24
30V/30		 300
115
90
50
40
6083-X0
6083-X1
6083-X2
6083-X4
6083-X6
6083-X11
6083-X11		 5
12
15
24
30
+/-12
+/-15		 1000
470
400
220
180
220
180
6084-X1 Adj
6084-X2 Adj
6084-X4 Adj		 7-13.5
14-22.5
22-28.5		 150
150
150
(1) Input voltages: substitute as below
X=0 for 5V DC
X=1 for 12V DC
X=2 for 15V DC
X=4 for 24V DC
X=7 for 48V DC
X=9 for 110V DC

Note: Some combinations of input and output may be on extended lead times.

Click here to enquire about this product | Amalgen Homepage

Amalgen Technologies Pty Ltd
43 Anderson Road,
Mortdale NSW 2223 Australia
Phone: +61 2 9570 2855
Fax: +61 2 9580 5128
 
© 2007 All rights reserved. Amalgen Technologies Pty Ltd.