Dual D.C. Linear Regulated Power Supply

Model 3535

D.C. Linear Regulated Power Supply available in dual output configurations and in fixed voltages from 5 volts to 24 volts. The regulators are temperature limited and time dependant current limited. The power supply incorporates a toriodal transformer which gives a low weight and small size. Other advantages are low external field and elimination of transformer hum.

Specifications
Input Volts: 240 volt 50/60 Hz, 110 volt 50/60 Hz (available)
Load Regulation: Better than 0.5% no load to full load
Line Regulation: Better than 0.5% for 10% change in input volts
Total Noise: Less than 20mV R.M.S.
Protection: None. Input fuses should be rated 5 to 10 times full load input current
Current Limit: 7A approx. Output is short circuit protected for models up to 24 volts
Ambient Range: 0° - 55° Celsius
Dimensions: See below

Model Output
Volts D.C.		 Output
Amps D.C.		 Typical full load
input current *		 Weight
kg
3535-X00
3535-X11
3535-X22		 5/5
12/12
15/15		 5/5
4/4
4/4		 0.75
0.93
1.1		 4.9
4.9
4.9

X = 0 for 110 Volts 50 Hz, X = 2 for 240 Volts 50 Hz, * 240V Input
 

Mains Input Variation: The power supply can be used at full output down to an input voltage of 210 Volts, however at low input voltages (below 240 volts) the output ripple will increase if the output current exceeds 4 X [mains input voltage-190]/50. Above 245 Volts the power supply can be used at full rated output however the maximum ambient temperature must be reduced by [mains input voltage-245] x 1 degrees celcius per volt. The input volts should not exceed 255V.

Non-standard Voltages: These power supplies are available for non-standard voltages.

Mounting: For maximum output power mount with the longest dimension vertical. Do not obstruct airflow.

Click here to enquire about this product | Amalgen Homepage

Amalgen Technologies Pty Ltd
43 Anderson Road,
Mortdale NSW 2223 Australia
Phone: +61 2 9570 2855
Fax: +61 2 9580 5128
 
© 2007 All rights reserved. Amalgen Technologies Pty Ltd.