|
|
|
| ||
| ||
| 24 Volt 20 Amp D.C. Regulated Power Supply
Model 5687 D.C. Regulated Power Supply available as standard in 24 volts 20 amp configuration. Other voltages from 5 to 30 are available on special order.The regulator is temperature limited and time dependant current limited. This power supply incorporates a 'C' Core transformer which gives a low weight and small size compared to a 'E-l' Laminated type. |
|
 |
| Specifications | |
| Input Volts: | 240 volt 50/60 Hz (110 volt 50/60 Hz available) |
| Load Regulation: | Better than 0.5% no load to full load |
| Line Regulation: | Better than 0.5% for 10% change in input volts |
| Total Noise: | Less than 20mV R.M.S. |
| Current Limit: | 28 amps approx. Output is short circuit protected for models up to 24 volts |
| Peak output current: | Minimum of 40A for 1m second |
| Meters: | 0-30 volts 60 x 70 mm, 0-30 amps 60 x 70 mm |
| Ambient Range: | 0° - 55° Celsius |
| Weight: | 23 Kg |
| Dimensions: | See below |
| Model | Output Voltage |
Output Current |
Input Voltage |
Typical Full Load Input Current |
| 5687-04 5687-24 |
24 24 |
20 Amps 20 Amps |
110 240 |
5.2 Amps 2.8 Amps |
Mains Input Variation: The power supply can be used at full output down to an input voltage of 210 Volts, however at low input voltages (below 240 volts) the output ripple will increase if output current exceeds nominal output X [mains input voltage-190]/50. Above 245 Volts the power supply can be used at full rated output however the maximum ambient temperature must be reduced by [mains input voltage-245] x 1 degrees celcius per volt. The input volts should not exceed 255V. Non-standard Voltages: These power supplies are available for non-standard voltages. |
| Click here to enquire about this product | Amalgen Homepage |
|
Amalgen Technologies Pty Ltd 43 Anderson Road, Mortdale NSW 2223 Australia Phone: +61 2 9570 2855 Fax: +61 2 9580 5128 |
| © 2007 All rights reserved. Amalgen Technologies Pty Ltd. |